There is a list of reasons why the system responsible for recognizing the hard drive. Once the report, the disk is write-protected media or may tell you to insert the disk, even if it is fixed. This error can occur when you try to insert a USB key or external hard drive. Sometimes it can leave a problem that can not be read or detect the hard disk. Mentioned below are some general tips for troubleshooting hard disk detection. However, you should check that can be applied to your case.
Windows Update can be the solution to your hard drive problem detection.
Remove all USB drivers older hard disks. Now you can install new drivers for goals hard to read the disc. Older drivers may confuse the windows, giving rise to send messages such as "drive letter conflict" or other problems in reading.
Use the AC adapter if you have a place to use the USB port on your system to load a variety of portable devices. It is strongly recommended to rely on AC adapters
Plug-in AC power for laptops to provide sufficient power to operate the disc correctly.
You can test drive different system to test the functionality of the system operating properly or not.
You can try using another USB cable to connect your hard drive in your machine.
If the hard disk with its own AC adapter so you may need to restart your system to see the hard drive.
If your hard drive depending on the power from the USB port itself, then sometimes you can not get enough power voltage. In this case, try connecting the hard drive in an area of self-powered via USB.
If the hard disk shown in disk management, not in "My Computer", you can easily correct. The problem may be due to bad sectors, so that you can give the manufacturer to remove bad sectors from hard disk. This problem can also be caused unallocated or not assigned to the drive. You can go to Disk Management and assign a drive letter to unallocated for this drive in "My Computer".
If only the hard drive will not connect to other devices such as printers and mice are working properly then you might have to check if your hard disk drivers are disabled.
If none of the above procedures are working and then even try to step below.
- Turn off computer and unplug it from the wall. Remove the battery pack or other if it is a laptop.
- Remove all USB devices, and disconnect the power supply of USB drives as well.
- Now, start a few hours everything correctly. Sometimes it can be the solution to the problems of reading hard drives.
No comments:
Post a Comment